M-Wave Shorttrackkufe
SakteTec
Produktinformationen "M-Wave Shorttrackkufe"
M-Wave is at the moment the most popular model on the market. Its unique delta shape gives more control and stability resulting in
more speed. Just like the Otto the M-Wave comes in four different stiffnesses ranging from Firm to Flex FT. Note that the height of the
Firm is not the same as the Flex
- Tube: 7000 Series Aluminum
Base height: 65mm
Blade: 1.1mm PM or Bi-Metal plesase cohoose
Stiffness: Firm, Firm FT, Flex and Flex F
Blade length: From 15.00 in up to 19.00 in in, steps of 0.25 in
Unique for the M-Wave are its 'M' shaped forks. The construction allows for a better transfer of the high loads while skating. They also distribute the stiffness more evenly over the tube. This results in higher stability and therefore more speed.
-
The Flex tube is thinner at the bottom of the tube. Less material near the blade lets the blade bend more into the corner, providing a more dynamic behavior. Flex tubes are more suited for lighter skaters.
-
The Firm tube has a bit more material at the bottom of the tube. This makes the skate stiffer, so it can keep its bend with higher forces. Firm tubes are more suited for heavier skaters. -
The standard tubes have a higher cross section in the middle of the tube. This makes a standard tube stiffer in the normal direction. A standard tube will hold its rocker more. -
The Flattop tubes are more flexible because of the lower cross section. The flattop tubes will therefore bend more when loaded. This causes the rocker to become flatter under load.
The trend in shorttrack is to go higher. Cups of +10mm are not a rarity anymore. The M-Wave Firm is therefore by default 5mm higher than normal. The M-Wave Flex is by default 3mm higher. Height is measured based on the default cup height of the Nagano, which is similar to other brands.
Preis für 1 Paar incl. Cups.
Die Lieferzeit der persönlichen Konfiguration wird erst nach Bestellung mitgeteilt. In der Regel 5-10 Werktage
Blade Material
| M-wave Flex | 62HRC Powder Metal |
| 62HRC BiMetal | |
| M-Wave Firm | 62HRC Powder Metal |
Tube Material
| Stiff 7000 series anodized aluminum |
Bend
| Pre-bent with a continuous radius of 25m |
Cups
| ST-Cups | |||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
Height options: -2 to +6 mm
|
|||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
|
Angled cups available upon special request |
Produktsicherheit
Hersteller
SakteTec
Anmelden
Keine Bewertungen gefunden. Teilen Sie Ihre Erfahrungen mit anderen.